5 May 2013
On to a new board
Hmmm so after several months of work I am still struggling to get all the gremlins out of the over-complex control panel. So I have turned my mind back to woodwork. Everytime you do woodwork you remind yourself that almost all wood you can buy is expensive and warped...
More expensive this time as I had a couple of big sheets of ply for the next couple of boards and so needed to pay a delivery charge from Inverness.
I have used my standard wall mounted L-girder technique - though the pictures below show with only one girder fitted.
I have used 100mm sections to hold baseboard surface rather than previous 90mm as this gives just a little more room for getting edge connectors on and off the Tortoise point motors.
